


VL100 C2 MINI LATHE
The Rolls Royce of mini lathes.
This version of the VL100 is ideally suited for fixing to a bench in a workshop situation rather than being used as a demonstrators lathe. Because the motor is fitted outboard and not underneath as with the EVS the lathe is not as tall, also access to the bottom pulley is through the panel on the front of the lathe with the belt tension locking lever mounted on the headstock leg. Apart from these differences it has the same motor size and inverter.
It's features.
Extra heavy-duty castings for the headstock, lathe bed, banjo and tailstock.
Camlock banjo and tailstock for secure locking.
Heavy Duty cast iron legs with a 350mm wide footprint and pre-drilled anchor points.
One piece headstock spindle machined from K1045 steel with high quality, taper roller bearings.
2MT headstock spindle and tailstock quill with 10.5 mm knock out through hole. and laser etched measuring scale.
Chromed hand wheel for easy rotation of work piece.
24 point indexing/spindle lock.
J5 Poly V Drive belt for maximum power transmission.
55 Kw (3/4 Hp) Motor with electronic variable speed control.
Forward and reverse switch.
Bolt on bed extension facility. (500mm lengths).
Increased centre height from 100mm to 125 mm (10 “ Swing )
Increased length between centres to 350 mm (14 “)
Speed range from 10-1000, 20 – 2000, 30-3000 rpm.
SPECIFICATIONS:
Centre Height: 125 mm (10”)
Distance between centres: 350 mm (13 3/4”)
Indexing: 24 Point
Headstock spindle: 2 MT
Spindle thread: M33 x 3.5
Spindle bearings: Taper Roller
Tailstock quill: 2 MT
Knock out hole dia: 10.5 mm
Quill travel: 65 mm
Motor: 0. 55 Kw (3/4Hp)
Weight: 54 Kg (119 Lbs)
Overall length: 920 mm (36”)
Width: 270mm (10 1/2”)
Height: 500 mm (16”)
Centre height, i.e. bench to spindle centre 380 mm (15”)
Footprint 700 x 270mm (27 1/2” x 10 1/2")
PLEASE NOTE : SPECIFICATIONS ON THIS LATHE ARE APROXIAMTE AND MAY VARY SLIGHTLY TO THE ABOVE.