25mm - VM90 and VM100
25mm - VM120 and VM140

These jaws are used for expansion into small recesses and for firm holding of fine spindle work, such as earrings, chess pieces, etc. They are ideal for turning salt and pepper shakers. To turn very small articles, the jaws can be unscrewed and only the backing jaws can be used.

Shark jaws are so called because of their serrated inner and outer jaw surfaces. These extended jaws provide an aggressive hold. They hold cylinder spigots much more safely than standard jaws. They are much easier and faster than traditional jaws used to turn long workpieces. Available in 35mm and 45mm.

49mm, 58mm - VM90 and VM100
55mm, 68mm - VM120 and VM140

These jaws allow better access between the chuck body and the rear of the workpiece. They are also very practical when pre- turned workpieces or long workpieces have to be refastened. For example, when turning serviette rings or remounting rough turned work

36mm - VM90 and VM100
47mm - VM120 and VM140

This device has been designed as an aid to woodturning. It enables an item to be re- mounted on the lathe for finishing without risking further holding marks. This device can be fitted directly into a Vicmarc chuck via the standard jaws, or an insert can be supplied as an extra to allow mounting directly onto the spindle. Size: 300mm.

By removing one or more of the dovetail segments from these jaws, they are adaptable to a variety of uses. The wide range of expansion and contraction of the Uni- Chuck provides for unique adaptability when using these jaws.

148mm - VM90 and VM100
210mm - VM120 and VM140

This screw chuck has three alternative diameters of 50, 75 and 100mm to give optimum support to any size of work. Made from K1045 medium tensile steel. Fitted with the Glaser screw. Fits most lathes. Alternative thread sizes available by using Vicmarc chuck inserts. M33 x 3.5 available as direct thread.

Step Jaws, designed by the famous Australian woodturner and author Richard Raffan, are used for holding a range of spigot sizes with minimum jaw movement and without the necessity to change the jaws. Boxes are easily turned using the step jaws. The bottom can be turned by holding the rim without leaving unsightly pressure marks.

100mm - VM90 and VM100
128mm - VM120 and VM140

Dovetail jaws are designed for mounting bowls by expanding into a recess or clamping onto a spigot. The size indicated is the outside measurement of the jaw face when fully closed. Dovetail jaws provide approximately 25mm of expansion beyond their specified size.

100mm - VM90 and VM100
128mm - VM120 and VM140

The Screw Face Plate enables you to quickly remove the job from the Chuck and remount if necessary. Dovetail pick up will fit any Vicmarc Chuck.

The 70mm Dovetail Jaws were designed to accommodate work that vary between the standard Dovetail Jaws that are supplied with the Chuck and 100mmDovetail Jaws. Available only for VM90and VM100. 57mm, 69mm - VM90 and VM100

57mm, 69 mm - VM90 and VM100